D-GB66Q FUEL DISPENSER

D-GB66Q FUEL DISPENSER

FlowMeter Type : Optional

Accuracy :±0.2%

Pressure Loss (kg/cm): Under 0.25

Motor Voltage(V) :110V/220V/380V,50Hz/60Hz

Capacity(hp) :1HP(0.75kw)

Input Voltage : 110V/220V/380V,50Hz/60Hz

Nozzle :Auto Shut-off Nozzle

Environmental Condition :-40~~+55degree

Control Type : Solenold Vale Control Type

Preset : Function Provided(Small LCDIndicator)

Display(Counter) :Type LCD and Bright Backlight

Digit of Volume :0~~999,999(6 Digits),Decimal point can be changed

Digit of Amount : 0~~999,999(6 Digits),Decimal point can be changed

Digit of Unit price : 0~~9999(4 Digits),Decimal point can be changed

Digit of Total Range :0~~99,999,999,99

Optional Display Type: LCD and Bright Backlight

Digit of Volume : 0~~99,999,999(8 Digits),Decimal point can be changed

Digit of Amount : 0~~99,999,999(8 Digits),Decimal point can be changed

Digit of Unit price : 0~~999999(6 Digits),Decimal point can be changed

Digit of Total Range :0~~99,999,999,99

Totalizer :1~~9,999,999

Hose: 4.5m

Weight: 405kg

Dimension(L×W×H) : 1270 x 620 x 2420(mm)

Dimension(L×W×H)Of Qty of Container : 40ft: 28 20ft: 13

ch is allowed to be operative switch, which should be connected with intrinsic safety power or dealt with explosion-proof. Diagram 3-23: Photoelectric switch circuit Simple as operative switch, the trouble of operative switch largely caused by incorrect mechanical position is very common. Article III IC card-controlled fuel dispenser IC card-controlled fuel dispenser, just as its name implies, refers to a new kind of fuel dispenser that is conducted refueling with valid IC card, filling money being deducted from IC card after operation. As a new payment of refueling, the trouble of IC card accounts for a certain proportion. Thus, it is necessary to introduce IC card here. Filling IC card Appearance Filling IC card is same to finical IC card in terms of inner structure or appearance size, both complying with the standard fuel dispenser of ISO 7816. The appearance of filling IC card is showed in Diagram 3-24. Surface size of IC card is presented in Table 3-1. Diagram 3-24: IC card appearance Table 3-1: IC card surface size Card type Length (mm) Width (mm) Thickness (mm) ID-1 85.47~~85.72 53.92~~54.03 0.76~~1.05 ±0.08 The standard of IC card regulates that there are 8 touching point of C1~C8, showing 3-2. Table 3-2: definition of IC card touching point C1 Power supply (Vcc) C5 Grounding (GNV) C2 Reposition signal(RST) C6 No use (NC) C3 Clock signal (CLK) C7 Inlet/ outlet(I/O) As C4 and C8 are used there are not needed to setting. Inner structure of IC card chip Inner structure of IC card chip illustrated in Diagram 3-25 CPU: 8-digit microprocessor with 16-digit address bus (some with 16 MPU) COS memory: it is often used to store operating system of chip (COS--- Chip operation system). With enhance of COS function and CPU speed, the storage of COS become larger. Diagram 3-25: Inner structure of filling IC card ROM: read-only memory, a type of memory that normally can only be fuel dispenser read Flash: non-volatile computer memory that can be electrically erased and reprogrammed fuel dispenser

(Value) in State　　 CONFIGURATION　　 1 bin8 R(1-9) M　　 PR_Id　　 (01H) (1-8) W(1-2)　　 Identifier of the product dispensed by this logical nozzle.　　 The PR_Id (value 1-8) specifies the product the product　　 which is stored in the Product Database PR_ID (address　　 41H-48H).　　 0 = not product assigned　　 1 = product in Product Database with address 41H　　 2 = product in Product Database with address 42H　　 .　　 8 = product in Product Database with address 48H　　 Please note that the PR_ fuel dispenser Id referenced here may differ　　 from the PR_Id that is linked to the respective meter in　　 the Meter database. If the logical nozzle is a blended　　 product then this PR_Id will defiantly be different.　　 Please note that dispensers that do not permit this Data_Id　　 to be changed remotely should:　　 - Reject any write attempts with a Data_ACK value of 2　　 (Read OnlyNot Writable).　　 - Must set the Data_Id to the hard coded default value.　　 When a master resetcold start occurs on the dispenser　　 device the dispenser should reset this Data_Id to its　　 default value.　　 PCD Comment:　　 As with standard IFSF dispensers the PCD may or may　　 not need product nozzle meter configuration from the　　 SCCD. However it will be beneficial if the PCD can　　 have a hardcoded value for many of these parameters.　　FP31_2.21 IFSF - STANDARD FORECOURT PROTOCOL fuel dispenser Jun fuel dispenser

policy� and “politics�in this most political of White Houses is risible. Only one bit of domestic policy matters in the next few months—preventing the Democrats from taking over one or both Houses of Congress. And Mr Rove is in the thick of it. His legal problems, too, remain as hot as ever. Mr Rove has lived for months with the possibility that he may be indicted for “outing�an undercover CIA agent. He has appeared before a grand jury called by Patrick Fitzgerald, a zealous federal prosecutor, no fewer than five times. It is true that Mr Fitzgerald may be about to wind up his investigation. It is also true that speculation is reaching fever pitch (a recent claim on truthout.org that Mr Rove had already been indicted sent the political world into a frenzy). If Mr Rove is indeed indicted, he will be dumped and leave the White fuel dispenser House immediately; if he manages to escape indictment, he will have a weight lifted from his shoulders. Mr Rove is being downgraded in a much more ego-crushing way than any of this. He was nicknamed “The Architect�after he pulled the 2004 election victory out of the hat. But Mr Rove always wanted to be more than the designer of a couple of election triumphs. He wanted to build a permanent political realignment—to do for the Republicans what Franklin Roosevelt did for the Democrats. He wanted to use the culture wars to turn socially conservative blacks and Latinos into Republicans, and use Social Security reform to entice young people into the Republican fold. And he wanted to use the Medicare prescription bill to buy support among the growing crowds of the elderly. But rather than overseeing an electoral realignment, he now has to try to avoid a looming electoral meltdown. How many blacks are likely to vote Republican after the Hurricane Katrina fiasco? And how many Hispanics are likely to do so now that Congressman Tom Tancredo and other nativist Republicans have advocate fuel dispenser d felonising illegal immigrants and keeping them out with a wall? Mr Rove fuel dispenser